SPEED SLEEVE™ RAPID INSTALL KIT - 3ft COMPLETE KIT
Applying Flexo® braided sleeving by hand to wires and cables can be a time-consuming process, especially in your production environment. The Techflex® Speed Sleeve™ can improve the process for repetitive jobs and long runs. The easy-to-use tool is designed to accelerate the process. The practical Speed Sleeve™ base unit can accommodate any tube length and mount to a workbench, miter stand, or similar surface. Speed Sleeve™ fits sleeving directly to harnesses for a neat, snug, and efficient application. You can customize the tubes and layout to best suit your job. Your production team will save precious time and your wiring will be protected for a lifetime.
Sleeving Installation Instructions
Step One: Load Sleeving over tube.
Step Two: Push wire bundle through machine until it appears out of the tube.
Step Three: Pull both sleeving and wire bundle to desired length.Choosing The Correct Tubes
The tube length and diameter should be chosen based on the size and length of the cable bundle you are working with. Since the unsleeved cable bundle will pass through this tube, the tube’s diameter will limit your cable bundle size. So, if you get the 1" diameter tube, your cable bundles will need to be 1" in diameter or less. The 3 foot tubes are designed for cable bundles of up to 50 feet. The 3 foot tubes are designed for cable bundles of up to 100 feet. Actual lengths achieved may far surpass these limits, depending on the selection of sleeving and actual bundle size. Each different tube can be used with a range of expandable sleeving sizes as show here:
- 1/2" diameter tube will accommodate 1/2" to 3/4" expandable sleeving
- 1" diameter tube will accommodate 3/4" to 1-1/2" expandable sleeving
- 1-1/2" diameter tube will accommodate 1-1/4" to 1-3/4" expandable sleeving